Skip to content

Honeywell Gas Valve on a Water Heater

March 12, 2017

Steps to reset Honeywell Gas Valve on a Water Heater that is flashing 4 times and indicating Temperature Exceeded:

1. Turn the control off and unplug the thermocouple wire
2. Remove the front panel and unplug the cable connected to the circuit board
3. Let it sit around for 10 mins
4. Put everything back in including the panel
5. Light pilot and hold the temperature control button down for 40 some seconds
6. Turn temp control all the way up to VERY HOT
7. Wait 10 seconds
8. Turn the temp control to HOT
9. Wait 10 seconds
10. Turn the temp control to PILOT
11. Wait 10 seconds
12. Turn the temp control to HOT
13. If you are lucky, the burner will kick in

Use these instructions at your own risk.

Advertisements

From → Uncategorized

Leave a Comment

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: